I encountered my first issue with the Smal House top01.stl. This is my third attempt to print it, and it always fails with a mess as shown in the following picture. I ran it through an online stl repair tool, still… no clue as of now what the issue might be.
The first storey and the roof worked just fine.
Print time
0d15h58m32s
Filament Usage
138.12g PLA Matte
(no term)
Power Consumption:: 1.81kWh
I did add the doors, stairs and the trap door in Bambu Studio, so the do not need to be glued on, and are more incorporated into the model. Well, the trap door was a bit high up, and was printed ~1cm above the floor, with a lot of supports beneath… Need to pay more attention. Will rip it out, and glue a separately printed trap door there.
