In my pile of shame is The Slaughterer from Crippled God Foundry, which I 3d printed (resin printer) in Septembre 2023, and which is waiting since then for a paint treatment…
Now, that I got an FDM printer, I wanted to check how well suited it is compared to the resin printer for minis. So I printed the model again. I must say, I was quite surprised. The result is way better than I expected. Still, for minis, I think I will stick to using the resin printer.
But now I had the same model, twice unpainted… so time for a quick side project. I recently saw Paint Using GLUE || Grimdark Flesh Technique || Tzeentch Screamer, by the Grimdark Compendium and wanted to give this method a try, perfect model for that, as it basically is flesh only, except for the apron and meat chopper.
I started with an airbrush base coat of Molotow 238 grey blue dark.
This was followed by a zenithal coat of Molotow 237 grey blue light.
From below, I sprayed selected areas with Daler Rowney Process Magenta Ink and Schmincke leaf green Ink.
Using an old brush, I coated the model in superglue of low viscosity.